name: esp32-cam-eyes description: Set up ESP32-S3-CAM modules as visual sensors (eyes) for OpenClaw agents. Covers hardware identification, firmware flashing, WiFi configuration, and HTTP camera server deployment using PlatformIO + Arduino framework. Use when the user wants to give their agent physical vision, set up ESP32-CAM, connect a camera module, flash camera firmware, or troubleshoot ESP32-S3 camera issues. Supports Hiwonder/Freenove boards with GC2145, OV2640, and OV5640 sensors.

ESP32-CAM Eyes

Give your OpenClaw agent physical eyes using ESP32-S3-CAM modules.

Overview

Each ESP32-CAM module runs a lightweight HTTP server exposing /capture (single JPEG snapshot) and /stream (MJPEG live stream). Once connected to WiFi, the agent can grab images via curl for vision analysis.

Prerequisites

• Hardware: ESP32-S3 development board with camera sensor (Hiwonder, Freenove, or similar)
• Software: macOS or Linux with Python 3 installed
• Tools: PlatformIO CLI (pip3 install platformio), pyserial (pip3 install pyserial)

Quick Start

1. Plug in the ESP32-CAM via USB
2. Identify the serial port: ls /dev/cu.usb* (macOS) or ls /dev/ttyUSB* (Linux)
3. Identify the sensor model (critical — determines firmware config)
4. Create PlatformIO project, flash firmware
5. Connect to WiFi, test with curl -o photo.jpg http://<IP>/capture

For the complete step-by-step guide with firmware code, pin definitions, performance benchmarks, and troubleshooting: read references/setup-guide.md.

Key Decision: Sensor Type

The sensor model determines your firmware strategy:

If buying new boards, prefer OV2640 — hardware JPEG is significantly faster.

API Endpoints

Once flashed and connected:

Multi-Camera Deployment

Multiple ESP32-CAMs can join the same WiFi network for multi-angle coverage. Bind fixed IPs via router DHCP reservation to avoid IP changes on reboot.

Common Pitfalls

• Wrong sensor ID: Always verify PID before choosing firmware config
• Upload speed: Use 460800 baud, not 921600 (causes flash verification failures on many boards)
• WiFi band: ESP32 only supports 2.4GHz — ensure your router has a 2.4GHz SSID available
• QQVGA is slower than VGA: Counter-intuitive but true due to PSRAM DMA buffer efficiency; use XGA (1024×768) for best speed/quality balance